Ahmad Mostafa - Post Doc

Revision as of 12:25, 26 July 2011

Ahmad Omar Mostafa

Full name	Ahmad Omar Mostafa
Email	ah_mosta[at]encs.concordia.ca
Room #	EV13.205

I am materials engineer, I have a very good work experience in metals manufacturing, fabrication, and heat treating. Also, I have a very well knowledge in steel hardening on both scales (surface and through hardening) using several techniques, such as: electric resistance furnaces, salt bath furnaces, carburizing and carbonitriding, and flame hardening.

Education

January, 2011 - present, PhD student in Concordia University/Faculty of Mechanical Engineering, Montreal, Canada.

2006 - 2009, Masters Degree in Industrial engineering/Manufacturing and design from Jordan University, Amman, Jordan.

2000-2004, Bachelore Degree in Materials Engineering Techniques from Technical College, Baghdad, Republic of Iraq.

Research Fields

• Experimental investigation of phase diagrams
• Grain refinement of metals

Published Works

[1] A.I.O Zaid and A.O. Mostafa, Effect of addition of hafnium (Hf) on the mechanical behavior and wear resistance of zinc-aluminum alloy 5 (ZAMAK5), ICPR 21st, 2011, Stuttgart, Germany.

Work Experience

1- From 1/8/2009 to 12/01/2011:

Working for Qaraman Co. for Bolts and Spare Parts Ltd. as:

A Manager of steel heat treatment department.

2- From 1/10/2009 to 1/6/2010 (1st and 2nd semesters of 2009/2010):

Working for University of Jordan / Faculty of Engineering and Technology / Department of Industrial Engineering as a part time engineer, assisting in teaching the manufacturing processes laboratory:

i. Subjects involved:-

- Metal Casting

- Wear of Metals

- Mechanical Behavior

- Rolling of Metals

- Deep Drawing

- Blanking and Piercing of Sheet Metals

- Extrusion of Metals

3- From 1/9/2007 to 1/7/2009:

Working for Al-Balqa for Metals and Tools Co. as:

i. Technical Manager with the following duties.

- Technical Support for BOHLER special steels (Steel selection & steel heat treatment).

- Marketing of BOHLER special steels.

4- From 1/7/2006 to 31/8/2007:

Working for Al-Hijaz engineered machining establishment with its sister company (National Industrial Rehabilitation Company - NIRCO) as:

i. Marketing engineer of BELZONA products.

ii.Mechanical designer using AutoCAD.

5- From 20/11/2004 to 28/2/2006:

Working for SHEBA Metal Casting Company as:

i. Production engineer

ii. Heat treatment furnace operator.

iii. Patterns designe using AutoCAD software.

iv. Preparing daily reports explaining melting and heat-treatment procedures.