Ahmad Mostafa - Post Doc

From TMG
Revision as of 02:35, 30 August 2011 by Ahmadomar82 (Talk | contribs)
Jump to: navigation, search
This article is about the TMG member Ahmad Omar Mostafa
Ahmad Omar Mostafa
Picture 013.jpg
Full nameAhmad Omar Mostafa
Emailah_mosta[at]encs.concordia.ca
Room #EV13.205

I am materials engineer, I have a very good experience in metals manufacturing, fabrication, and heat treating. Also, I have a very well knowledge in steel hardening on both scales (surface and through hardening) using several techniques, such as: electric resistance furnaces, salt bath furnaces, carburizing and carbonitriding, and flame hardening. Furthermore, I worked with Prof. Adnan I.O. Kilani as a research assistant for designing and manufacturing metal forming dies (deep drawing and asymmetric-angle extrusion dies). To fulfill my ambition, I decided to complete my Ph.D study in Concordia University under the supervision of Dr. Mamoun Medraj as a step of coupling my practical experience with the academic part.

Contents

Education

PhD student in Concordia University/Faculty of Mechanical Engineering, under the supervision of Dr. Mamoun Medraj, Montreal, Canada.

Masters Degree in Industrial engineering/Manufacturing and design under the supervision of Prof. Adnan Alkilani, from Jordan University, Amman, Jordan.

Bachelore Degree in Materials Engineering Techniques from Technical College, Baghdad, Republic of Iraq.

Research Fields

Published Works

[1] A.I.O Zaid and A.O. Mostafa, Effect of addition of hafnium (Hf) on the mechanical behavior and wear resistance of zinc-aluminum alloy 5 (ZAMAK5), ICPR 21st, 2011, Stuttgart, Germany.

Work Experience

1- From 1/8/2009 to 12/01/2011:

Working for Qaraman Co. for Bolts and Spare Parts Ltd. as:

Manager of steel heat treatment department.

2- From 1/10/2009 to 1/6/2010 (1st and 2nd semesters of 2009/2010):

Working for University of Jordan / Faculty of Engineering and Technology / Department of Industrial Engineering as a part time engineer, assisting in teaching the manufacturing processes laboratory:

i. Subjects involved:-

- Metal Casting

- Wear of Metals

- Mechanical Behavior

- Rolling of Metals

- Deep Drawing

- Blanking and Piercing of Sheet Metals

- Extrusion of Metals

3- From 1/9/2007 to 1/7/2009:

Working for Al-Balqa for Metals and Tools Co. as:

i. Technical Manager with the following duties.

- Technical Support for BOHLER special steels (Steel selection & steel heat treatment).

- Marketing of BOHLER special steels.

4- From 1/7/2006 to 31/8/2007:

Working for Al-Hijaz Engineered Machining Establishment with its sister company (National Industrial Rehabilitation Company - NIRCO) as:

i. Marketing engineer of BELZONA products.

ii.Mechanical designer using AutoCAD.

5- From 20/11/2004 to 28/2/2006:

Working for SHEBA Metal Casting Company as:

i. Production engineer

ii. Heat treatment furnace operator.

iii. Patterns designe using AutoCAD software.

iv. Preparing daily reports explaining melting and heat-treatment procedures.

Personal tools
Namespaces
Variants
Actions
Navigation
Group Navigation
Teaching
Intranet
Toolbox