MECH 421 - Mechanical Shaping of Metals and Plastics
From TMG
(Difference between revisions)
Ahmadomar82 (Talk | contribs) (→Lecture Notes) |
Ahmadomar82 (Talk | contribs) (→Lecture Notes) |
||
Line 20: | Line 20: | ||
*[http://users.encs.concordia.ca/~mmedraj/mech421/lecture%201_introduction.pdf Lecture 1 - Introduction] | *[http://users.encs.concordia.ca/~mmedraj/mech421/lecture%201_introduction.pdf Lecture 1 - Introduction] | ||
− | *Lecture 2 - Review of Mechanical Properties | + | *[http://users.encs.concordia.ca/~mmedraj/mech421/lecture%202_%20mechanical%20properties.pdf Lecture 2 - Review of Mechanical Properties] |
− | *Lecture 3 - Fudamentals Metal Forming | + | *[http://users.encs.concordia.ca/~mmedraj/mech421/lecture%203%20metal%20Forming%20Fundamentals.pdf Lecture 3 - Fudamentals Metal Forming] |
*Lecture 4 - Forging and Its Analysis | *Lecture 4 - Forging and Its Analysis | ||
*Lecture 5 - Rolling and Its Analysis | *Lecture 5 - Rolling and Its Analysis |
Revision as of 23:42, 22 November 2012
This page is about MECH 421/6511 - a course used to be taught by Dr. Medraj
MECH 421/6511'S Announcements
- Some announcements come here!
Maybe a brief information about the course might come here? Maybe a brief information about the course might come here? Maybe a brief information about the course might come here? Maybe a brief information about the course might come here? Maybe a brief information about the course might come here? Maybe a brief information about the course might come here? Maybe a brief information about the course might come here? Maybe a brief information about the course might come here?
Lecture Notes
- Lecture 1 - Introduction
- Lecture 2 - Review of Mechanical Properties
- Lecture 3 - Fudamentals Metal Forming
- Lecture 4 - Forging and Its Analysis
- Lecture 5 - Rolling and Its Analysis
- Lecture 6 - Extrusion and Drawing
- Lecture 7 - Review of Bulk Forming Processes
- Lecture 8 - Sheet Metal Working: Cutting and Bending
- Lecture 9 - Deep Drawing
- Lecture 10 - Other sheet metalworking processes
- Lecture 11 - Review of sheet metalworking processes
- Lecture 12 - Powder Metallurgy
- Lecture 13 - Ceramics
- Lecture 14 - Shaping of Plastics - Introduction
- Lecture 15 - Midterm Exam
- Lecture 15 - Shaping of Plastics - Extrusion
- Lecture 16 - Shaping of Plastics - Injection Molding
- Lecture 17 - Shaping of Plastics - Blow molding and thermoforming
- Lecture 18 - Review of Polymers
- Lecture 19 - Machining I
- Lecture 20 - Machining II
- Lecture 21 - Machining III
- Lecture 22 - Machining IV
- Lecture 23 - Friction, Lubrication and Wear
- Lecture 24 - Rapid Prototyping and Microfabrication
Assignments
- Assignments
- Assignments
- Assignments
- Assignments
- Assignments
- Assignments